CH Ceramic heaters, Radiant heaters by BN Thermic

Product selector

CH

Ceramic Heaters

Providing virtually instant comfort heat in a variety of commercial buildings.
Especially suited to irregularly used buildings where conventional space heating is impractical.
Avoids the light output associated with shortwave infrared heaters
Ideally suited to spot heating a defined area within an otherwise unheated space
Low running costs by selecting from a range of control options

Typical Applications

Please note ceramic heaters are best suited to buildings with relatively low ceilings

Community halls
Workshops
Kennels
Zoos

Features Common to all Models

Aluminium construction with safety grille
Long life ceramic heat emitters
High quality ivory paint finish
Wall mounting bracket and providing ‘up and down’ and ‘side to side’ angle adjustment

Controlling CH Heaters

As CH ceramic heaters are virtually 100% effective the instant they are switched on, we recommend a control system that will de-energise a heater when heating is not required. This can be achieved by means of a Push Button Timer or a Movement Detector.

Push Button Timer – TS-3 pre-programmed time delay

The BN Thermic TS-3 is a compact, surface mount, weatherproof device conforming to IP66. A simple push button will energise a heater or heaters for a pre-programmed period between 2 minutes and 2 hours. Once this period has elapsed the heating will be automatically switched off until the button is pushed again. The device is vandal resistant and tamperproof meaning only authorised personnel can adjust the time settings. For full details of the TS-3 click here.

The TS-3 has a switching capacity of 16A. It can therefore directly switch a combined load of up to 3kW. Larger loads or 3-phase loads can be switched via a suitably rated contactor.

Push Button Timer – TS-4 user selectable time delay

The BN Thermic TS-4 is designed for installation into a standard single-gang back box. A simple push button provides 15 minute/ 30 minute / 1 hour / 2 hour settings. Once the selected period has elapsed the heating will be automatically switched off until the button is pushed again. The time setting can be changed at any point during the cycle and the timer also provides a means of switching the heating off. For full details of the TS-4 click here.

The TS-4 has a switching capacity of 13A. It can therefore directly switch a combined load of up to 3kW. Larger loads or 3-phase loads can be switched via a suitably rated contactor.

Movement Sensor

The BN Thermic WH-402 is a compact, surface mount, weatherproof device conforming to IP55. The WH-402 will detect movement in an area up to 12m from its mounting position in a 180° arc. Both distance and angle of detection can be reduced if required. Once movement has been detected, the heating will be switched on. If no further movement is detected within a pre-programmed time period (5 seconds to 18 minutes) the heating will be automatically switched off.

The device is vandal resistant and tamperproof meaning only authorised personnel can adjust the time settings. For full details of the WH-402 click here.

The WH-402 has a switching capacity of 16A. It can therefore directly switch a combined load of up to 3kW. Larger loads or 3-phase loads can be switched via a suitably rated contactor.